0

my composition width is 4480

I have 2 layers with a gradient ramp on each

once I've entered the start and end position of the gradient on the first layer I need to have the opposite equivalent start and end position values of that gradient generated in the second layer's gradient.

So with a comp width of 4480 if gradient 1 start x is 1000 and end x is 1250 then gradient 2 start x should be 3480 and end x is 3230. The Y is going to have a fixed position.
Ideally I'd like to tie in the start x and end x of the first graident to an expression control such as a slider so i can adjust the position of the points simultaneously.

0

This is very similar to your other question: In After Effects how can I generate the value of an opposite x position and then send that value to an effect on another layer?

The answer is the same. Use a pick whip to link two controllers together.

1
  • yes i tried the answer on the other question but that seemed to duplicate the output of the first gradient onto the other layer, if i change the start point on gradient 2 as on the answer on the other question then it shifts the two x's apart so i figured i must be asking the question incorrectly. I'm obviously a bit lost when it comes to pickwhipping two controllers together to get the desired outcome – tpg Feb 8 at 17:28

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.