I have a video source that, to my surprise, has a lot more detail than I could at first see. Turning down gamma I could see details in a bright part, turning up gamma I could see details in a darker part. I did experiment with brightness for obvious reasons, as well as with saturation, but I seem to be stuck at 50% of the details. Is there really such a predicament in video reproduction that you have to sacrifice one for the other, is my monitor involved (pre-retina Macbook), or have I simply not found the sweetspot of all those image tweaks?

  • Usually when I see this happen, if I look at the histogram of my clip, it's "U" shaped. There's a lot of pixels near black and a lot near white and not much in-between. This usually happens when shooting mid-day on a very bright day, though there are other possibilities. I concur with @AJHenderson - use Curves if it's available. Commented Jul 30, 2016 at 5:42

2 Answers 2


You want to adjust a mix of gamma, brightness and contrast, or if available, simply use curves. Gamma impacts the way in which the output intensity corresponds to input intensity, but if you don't also adjust other settings, you will still end up clipping key details outside of either the signal range of your signal or the display range of your display.

Using curves gives the most flexibility to adjust the amount of contrast in each portion of the range of signal intensity so that you can see everything clearly, however it is also possible you are simply near the effective limit of the range your display can produce depending on where the information you need contrast for is.

I suggest starting by trying to make sure your contrast or black point (on curves), is set such that you can tell the difference in shadow detail and then trying to adjust the brightness or white point (in curves) to get it so you can just tell difference in light detail and then try adjusting gamma to give you the needed spread.


Looks like you are ready to enter the world of Lift-Gamma-Gain! These are the three controls that most colorists use to tame light and the sensors that record it. AJ Henderson is putting you on the right path, with suggestions that there's more to image control than just gamma, levels, curves, etc., but really you will find a lot more resources by researching the subject of Lift, Gamma, Gain. (It's so fundamental that the bboard for professional colorists is liftgammagain.com)

Here's a graph that helps show how these three controls interact:

Lift Gamma Gain Curves

Once you are good with that, you might like to play with lift gamma and gain in log space, which are called shadow, midtone, and highlight:

Shadow Midtone Highlight

There are many who will argue long and hard about which is best, most useful, most true, etc. I have found LGG is better for creatively manipulating the look of an image, whereas SMH is better for being more surgical. Explore and report back!

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.