I've seen this before, but I want to get to the bottom of it (I hope) so I can prevent it from happening again. I have a video with a few dozen stabilized clips. Looks good, though I want cross dissolves between each clip. That works fine, but sometimes going in or out of the transition causes a jump, as if the stabilization settings were different for the transition. For an example, take a look at this video... especially the start and end of the clip that runs from 00:31-00:43. http://dangoodspeed.com/shared/12n-downtown-schenectady-fire
2
-
When you're doing the dx, have the stabilized clips been rendered? IOW, depending on the order of operations the dx may be happening before stabilization.– Jim MackCommented Mar 14, 2015 at 16:23
-
Yes they were rendered before I did the dx. One thing I noticed today is that the error happens when different types (inertia vs smoothcam) are used on the clips surrounding the transition.– Dan GoodspeedCommented Mar 15, 2015 at 16:06
Add a comment
|
1 Answer
Instead of using a crossfade transition effect, use opacity keyframes in the video animation menu. Select your clip and press "control + v".
